原硬盘是nvme的海力士p44pro，移动盘是三星t5.
又一次测试，dism++备份镜像成wim勾选了可启动，用wim利用wt ...
进PE，用这个修复引导。在PE双击后，点击C:，选择1，开始修复。只要能看到修复成功这4个字就可以重启了。不包好。
LIANGX 发表于 2024-1-4 15:02
原硬盘是nvme的海力士p44pro，移动盘是三星t5.
又一次测试，dism++备份镜像成wim勾选了可启动，用wim利用wt ...
如果修复引导后还是相同的0xc000000f的错误代码，在这个图中按F8，选择以安全模式运行。如果能进桌面，重启，正常进桌面，进不去的话，不知道；还是相同的错误代码，我也不知道怎么整。 john185 发表于 2024-1-4 14:00
“傲梅分区”可以的，克隆了多次
傲梅不行，DG可以。 e0yue 发表于 2024-1-5 16:58
傲梅不行，DG可以。
遇到过，哪怕备份原有的引导还原后就出现楼主的情况，解决方法进pe里重新修复引导 本帖最后由 乔治 于 2024-1-16 22:56 编辑
除了引导记录问题修复外，如果还不能顺利启动，遇到蓝屏inaccessible boot device，则需要离线进注册表修改键值，让系统优先加载usb协议。参见外网讨论：
make Windows load the USB drivers sooner:
Press WinR, type regedit and hit Enter
Enter HKLM\SYSTEM\HardwareConfig\ in the address bar at the top
On the left, choose the entry with the UUID of the boot partition
Change BootDriverFlags's value to 14 (hexadecimal)
refer to:
The operating system can promote a driver's StartType to be a boot start driver depending on the BootFlags value specified in the driver's INF. You can specify one or more (ORed) of the following numeric values in the INF file, expressed as a hexadecimal value:
If a driver should be promoted to be a boot start driver on network boot, specify 0x1 (CM_SERVICE_NETWORK_BOOT_LOAD).
If a driver should be promoted on booting from a VHD, specify 0x2 (CM_SERVICE_VIRTUAL_DISK_BOOT_LOAD)
If a driver should be promoted while booting from a USB disk, specify 0x4 (CM_SERVICE_USB_DISK_BOOT_LOAD).
If a driver should be promoted while booting from SD storage, specify 0x8 (CM_SERVICE_SD_DISK_BOOT_LOAD)
If a driver should be promoted while booting from a disk on a USB 3.0 controller, specify 0x10 (CM_SERVICE_USB3_DISK_BOOT_LOAD).
If a driver should be promoted while booting with measured boot enabled, specify 0x20 (CM_SERVICE_MEASURED_BOOT_LOAD).
If a driver should be promoted while booting with verifier boot enabled, specify 0x40 (CM_SERVICE_VERIFIER_BOOT_LOAD).
If a driver should be promoted on WinPE boot, specify 0x80 (CM_SERVICE_WINPE_BOOT_LOAD)
页:
1
[2]